Medion Navigation UnitNavigation Unit Manuel d'utilisateur télécharger pdf (Page 38)

Adjusting the settings

Adjusting the device settings

Choose from the following setting menus:

• Volume

• Screen settings

• Power management

• Security settings (depending on device)

• FM transmitter (depending on device)

• Restore factory settings

Tap one of the buttons to open the corresponding sub-menu. To close the menu again, tap the

button.

Volume settings

In this sub-menu, you can set the volume individually for the voice output, the key click and audio

playback of MP3 files via the additional MP3 player application. The volume set here applies

equally to playback via the internal speakers and via the earphone connection (3.5 mm mini jack)

on your navigation device.

The buttons and allow you to individually lower or raise the volume for the respective signal

output in seven steps. Output for the respective signal is muted at the lowest level.

Screen settings

This sub-menu allows you to individually adjust the brightness settings for daytime/nighttime op-

eration and to calibrate the screen.

• When you tap the Setup brightness button, you can individually lower or raise the Bright-

ness level daytime and Brightness level nighttime to six levels using the and buttons.

• Tapping the Calibrate display button allows you to recalibrate the touchscreen of your na-

vigation device. This becomes necessary when the entries on the touchscreen no longer corre-

spond to the actions performed: For example, the assignment of keys to appropriate symbols or

commands may deviate from the instructions.

To calibrate the device, follow the instructions on the screen by tapping the target sign. Finally, ac-

cept the new settings by tapping the screen again.

Note

If you format the flash memory of your navigation device in order to, for example, update

to a newer version of the software, the screen must also be recalibrated during installa-

tion (refer also to the device manual).

The brightness settings will be saved and the stored value will be used the next time

your start-up your navigation system.

Power management

This sub-menu enables you to adapt the energy options for either battery or mains operation. The

current charge of the battery is displayed on a bar chart on the lower portion of the screen.

• If you tap the selection menu under the entry In battery mode you can select one of the follow-

ing options from the list in the relevant pop-up menu:

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 54 55

Pas de commentaire

Medion Navigation UnitNavigation Unit Manuel d'utilisateur Page 38