Medion Navigation UnitNavigation Unit Manuel d'utilisateur télécharger pdf (Page 27)

Operating the GoPal

navigation software

o If the arrow key is active, navigation is enhanced with the arrow view in addition to the

map: When there is an upcoming manoeuvre, arrow orientation indicates how you will be

directed during the manoeuvre. The distance to the next manoeuvre is shown on the

segment chain located next to the arrow.

• Within the map section, the planned route is shown in blue. In case of a manual or automatic

traffic jam avoidance, the alternative route is shown in red.

• The street on which you are currently located is shown on the upper edge of the screen. Prior to

a manoeuvre, the direction of navigation is shown in the arrow view, as is the distance to ma-

noeuvre. A-roads and motorways are distinguished by colour and their number.

• Your current position is displayed on the map using the symbol.

• Information regarding the current and average speed, the distance to the destination, remaining

travel and arrival time (only in the 480 x 272 pixel) is shown on the information bar on the lower

edge of the map display (see also Operation in the map view ).

• You can adjust the desired map zoom in the menu Settings > Display > Auto-zoom (see the Ad-

justing the display section). You can adjust the zoom of the map section manually using the

and buttons as needed. The current scale is displayed on the map.

• POIs such as petrol stations, rest areas etc. are displayed as symbols in the map display. You

can determine which point of interest categories should be displayed with the menu Settings >

Display > Points of interest settings.

Tip

You can manually move the current map section within the screen if needed, in order to,

for example, show the POIs in the area of the calculated route in the map view. To do so,

tap a suitable position in the map section, hold the position and move it around the

screen as desired: The map section is adjusted accordingly.

In addition to the visual navigation, all manoeuvres are announced by voice commands at the

same time, provided you have activated the feature in the menu Settings > Voice announcements.

You can adjust the voice output during navigation as follows:

• Tap the button in the upper left area of the screen: The setting menu Volume then opens,

which allows you to individually set the volume for voice output, the key click and audio play-

back of MP3 files using the additional MP3 Player application. The volume set here applies

equally to playback via the internal speakers and via the earphone connection (3.5 mm mini

jack) on your navigation device.

o The buttons and allow you to individually lower or raise the volume for the respec-

tive signal output in seven steps. Output for the respective signal is muted at the lowest

level.

Note

The volume setting is saved and the stored value will be used the next time you start-up

your navigation system.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 54 55

Pas de commentaire

Medion Navigation UnitNavigation Unit Manuel d'utilisateur Page 27