
Operating the GoPal
®
navigation software
26
Arrow view
In the arrow view, you are guided by a guidance system based on arrows, independent of a map.
The arrow view provides the following information:
• The current direction of travel is described using the arrow. When there is an upcoming
manœuvre, the orientation of the arrow indicates in what direction you will be led during the ma-
noeuvre. Depending on the manœuvre, side streets may also be displayed, but the main route
is always clearly marked.
• The distance to the next manœuvre is shown using the segment chain beside the arrow: The
closer the manœuvre comes, the more segments in the chain are filled. This allows you to read-
ily estimate the actual distance from the manœuvre based on your speed.
• The street on which you are currently located is shown on the upper edge of the screen, as is
the route that you must travel on this street to the next manoeuvre. A-roads and motorways are
distinguished by colour and their number.
• If manoeuvre is imminent, the display is switched: Now the distance to the manœuvre is shown
as well as the street/direction in which you will be guided after the manoeuvre.
The information bar in the lower portion of the window shows all of the other information about the
current route (such as speed, distance, calculated travel time etc.).
Trip info
In the Trip info view, the following information is displayed about the current navigation:
• Maximum speed
• Average speed
• Route travelled
• Travel time
This information refers to all of the routes travelled since the last time the Trip info was reset (see
below). To measure information about a specific route, you must reset the trip info at the start of
navigation. To do this, activate the button: All values are reset to 0 and the measurement is re-
started.
Note
The values in the Trip infos are automatically reset to 0 if your navigation device has re-
ceived no valid GPS data packet in two hours.
Commentaires sur ces manuels