Medion GoPal Manuel d'utilisateur télécharger pdf (Page 9)

GoPal Navigator 4

Chapter 2 Manual installation and

start-up

The Windows CE operating system has already been installed on your navigation device. In addi-

tion, software components such as the navigation software or map material for various countries

(depending on the version) may already be pre-installed on the device or on the memory card

supplied. If that is not the case, you must first install the navigation software as well as the map

material necessary for route planning before operating your navigation system.

If you are updating or would like to install subsequently purchased navigation software or addi-

tional maps or POI files to your navigation device, you must remove individual or all data installed

on your device before installing the newly purchased software. The following data can be manually

installed by the user:

• GoPal

Navigator navigation software

• Map material in the form of PSF files

• Point of interest data (POI data) in the form of PSF data

Tip

Even though it is possible to install files manually, we recommend that you use the Go-

Pal

Assistant supplied with the software to transfer and update software components on

your navigation system. The next chapter describes the installation and data exchange

using the GoPal

Assistant.

The manual transfer of software components from CD/DVD to your mobile navigation device takes

place in Windows Explorer on your PC. Select one of the two following methods to exchange data

between your navigation system and your PC:

• If you have installed the Microsoft ActiveSync

software from a CD/DVD, you can connect your

navigation device directly to the USB port of your PC using the USB cable supplied in order to

synchronise the desired data. In this case, you have direct access to the internal flash memory

of your navigation device.

• If your PC has a card reading device, you can insert the external memory card supplied di-

rectly and manually move the data in the file explorer. In this case, you do not have direct ac-

cess to the internal flash memory of your navigation device.

Initial operation

Depending on the version of your navigation system, the software necessary for operation may not

have been pre-installed on your navigation device and can instead be found on the memory card

supplied: an appropriate comment indicating this can be found in the readme file as well as on the

packaging of your navigation device. In this case, you must install the software to operate your na-

vigation system.

Proceed as follows to install:

1. Carefully remove the memory card from its packaging. Take care that the contacts are not tou-

ched or contaminated: Otherwise data transfer may no longer be possible.

2. Insert the memory card into the MMC/SD card slot of your navigation device until you hear a

click.

3. Switch on the navigation device by pressing the ON/OFF switch on the device (see device op-

erating instructions).

The necessary software components will now be installed automatically.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Medion GoPal Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de navigation pour voitures Medion GoPal