Medion GoPal Manuel d'utilisateur télécharger pdf (Page 51)

Operating the GoPal

navigation software

Tip

Your navigation system uses the signals from several satellites to determine the position.

There may be overlap between the section areas of these satellite signals which reduces

measuring accuracy. The HDOP value indicated in the compass describes the measur-

ing accuracy within the horizontal 2D map: For values in the range to 6, a high to satis-

factory measuring accuracy is guaranteed, for values over 6 deviation is increasingly

common.

Note

If a speed limit has been entered for the current route section, it is displayed in the left

corner using the symbol: A spoken warning only occurs if the option Speed limit in the

menu Settings > Program settings has been set and the speed has been exceeded by

this value.

Arrow view

You can call up an alternative view to the map display in the Quick menu. In the arrow view, you

are guided by a guidance system based on arrows, independent of a map. In addition to the arrow

which describes the next or current manœuvre, the arrow view offers the following information:

• The current direction of travel is described using the arrow. When there is an upcoming

manœuvre, the orientation of the arrow indicates in what direction you will be led during the

manoeuvre. Depending on the manœuvre, side streets may also be displayed, but the main

route is always clearly marked.

• The distance to the next manœuvre is shown using the segment chain beside the arrow: The

closer the manœuvre comes, the more segments in the chain are filled. This allows you to

readily estimate the actual distance from the manœuvre based on your speed.

• The street on which you are currently located is shown on the upper edge of the screen, as is

the route that you must travel on this street to the next manoeuvre.

• If manoeuvre is imminent, the display is switched: Now the distance to the manœuvre is

shown as well as the street/direction in which you will be guided after the manoeuvre.

The information bar in the lower portion of the window shows all of the other information about the

current route (such as speed, distance, calculated travel time etc.).

Trip info

With Trip info, you can call up an alternative view to the map display via the Quick menu. The fol-

lowing information is displayed in this view:

• Maximum speed

1 2 ... 46 47 48 49 50 51 52

Pas de commentaire

Medion GoPal Manuel d'utilisateur Page 51