Medion GoPal Manuel d'utilisateur télécharger pdf (Page 47)

Operating the GoPal

navigation software

the Starting and displaying navigation section.

Route information

The route information menu enables you to call up important information about your planned route,

simulate the route and calculate alternate routes.

Directions

Once you have started navigation for a route (new destination or saved tour), the Directions but-

ton is available. The directions tell you which roads to use to reach your destination. All route in-

formation, along with the distance, is shown in a list on the Directions screen, serving as a preview

of the planned manoeuvre. If the planned route cannot be displayed on a single screen, you can

browse through the list using the and buttons. Border crossings into other countries are

marked for better orientation.

When you wish to exit the directions screen, use the button to return to the selection menu for

route information.

Traffic conditions

This function enables you to display current traffic information received by your navigation system

in a list and call up specific pieces of information. Proceed as follows to configure reception of traf-

fic information:

1. Tap the button Traffic information. The Traffic situation screen then appears.

2. Tap on the TMC Settings button in the lower portion of the screen: The menu TMC settings is

then opened in the Program settings of your navigation system.

3. Adjust the reception of the TMC services as needed: This process is described in the

Adjusting the Program settings section.

Note

The TMC reception status is displayed using the indicator in the map view

as well as on the Traffic situation screen. If reception is disrupted, your navigation sys-

tem is unable to receive traffic reports.

After configuring the TMC station settings, you can take advantage of the available traffic informa-

tion services. Proceed as follows to show current information about traffic conditions:

1. Tap the button Traffic information. The Traffic situation screen then appears. The appropriate

list then displays the traffic reports affecting your route: These entries are labelled with red traf-

fic signs (e. g. ). The order of the entries depends on the distance from your location.

The lower part of the list also displays results not on your route: These entries are labelled with

grey symbols (e. g. ) and are in alphabetical order.

You can browse through the list of traffic reports using the and buttons.

2. Tap the desired entry in the list to display the traffic report in the detailed view: The route, the

route section, the type and length of the traffic disruption are described in the text of the traffic

report. If the traffic disruption will influence your travel time, (traffic jam, stagnant traffic), the

estimated loss of travel time is also displayed

If no alternate route can be calculated, the warning symbol on the map disappears but you can

select the traffic disruption relevant to your route from the list view once again and then have

an alternate route calculated in the traffic warning view.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

Commentaires sur ces manuels

Pas de commentaire

Medion GoPal Manuel d'utilisateur Page 47

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de navigation pour voitures Medion GoPal