Medion Navigation system Manuel d'utilisateur télécharger pdf (Page 16)

User's manual MEDION-Navigator 5

- 14 - Installing the hardware

2.2 Installing the hardware

2.2.1 Installing the PNA in the vehicle

Attention: The mounted holder must not interfere with the

driver’s attention to traffic. In case this is not possible, use the

provided adhesion plate to mount the holder somewhere else so

that safe driving is granted.

Note: You need not execute steps 1 and 2 if you want to mount

the holder on your windscreen.

Mounting the

holder...

1. Remove the lamination sheet from the adhesion plate.

2. Stick the adhesion plate at a convenient place on the

dashboard. Make sure that the surface of the dashboard is

clean and dry and press the plate forcefully on its place.

Note: Do not charge the plate for the first 24 hours in order

to grant its hold.

3. Attach the cradle of the device to the swan-neck mount.

Note: Take notice of the inscription on the swan-neck mount.

The arrow with the inscription close must show in snap-on

direction. The connection must snap on audibly.

4. Place the suction cup on the adhesion plate (or directly on the

windscreen) and press the lever on the suction cup down. The

suction cup adheres to the plate (or to the windscreen).

5. Insert the device into its holder. First place the bottom of the

device correctly, then push it backwards until it snaps into the

clip.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 111 112

Pas de commentaire

Medion Navigation system Manuel d'utilisateur Page 16